Watch these videos to see if the Rib-O-Lator
will fit your grill
You can check to see if the rib-o-lator will fit your
grill by doing the following.
You will need a tape measure.
1st place your rotisserie rod and motor onto your grill
2nd remove the grill grates (cooking surface)
3rd depth: (up and down) from the center of the rotisserie rod measure down to the heat plate covering your burners. You will need 6 inches clearance, if you do not have 6 inches, then remove the heat plate covering the burners and re-measure.
4th length: (end to end) now measure lengthwise. You will need 20 inches from end to end.
5th width: (front to back) now measure the width. You will need 61/2 inches on each side of the spit rod for a total of 13 inches. The video says 101/2 inches but this is incorrect.
The Rib-O-Lator will fit on 99 percent of the grills one the market. the only ones it may not fit are the smaller inexpensive grills.the Rib-o-Lator trays measure 5'' x 17'' x 4 trays = 340 sq inches of cooking surface.
Part I
Part II
If you have a question about the Rib-O-Lator
contact me at
info@ribolator.com
or call me at 206-999-0962 ask for Bob.
