Assembly Instructions for The Rib-O-Lator™
 |
START HERE...
The Rib-O-Lator™ fits medium and large gas grills (most small grills do not have enough clearance). BEFORE assembling the Rib-O-Lator check to see that there is clearance for it to rotate freely without hitting anything.
Here's How: Install your empty rotisserie rod on your grill. Measure from the burner cover to the center of rod as shown. You need 5¾ inches of clearance. If it's close, and you need just a little more room, you can take the covers off your burners to give you the extra room you need. Now assemble the Rib-O-Lator™, and install on your grill (with heat off) and turn rotisserie motor on - rotate the unit a couple revolutions to visually double check that it isn't hitting anywhere and rotates freely.
|
 |
Step 1
Put both brackets on your rotisserie rod with pins facing
IN toward each other as shown. Space brackets apart about
the length of the tray - approx 18". Now tighten thumbscrew
on only ONE bracket, leaving the other loose.
Use pliers to tighten securely (do the
same on Step 4.)
Step 2
With trays resting on flat surface, insert the bracket
pins into trays as shown.
Important! For proper bracket alignment
entire assembly process should always be done while resting
on a flat, even surface as shown.
Step 3
Now insert the two top trays.
Step 4
Adjust loose bracket as needed -- move it closer or further
away until edges of trays are more than halfway on the pin
as shown.
It needs to be loose enough to rotate freely, yet so
tray cannot be removed during
operation. Now tighten last thumbscrew tightly with
pliers and install in your gas grill.
Parts List:
- 4 four slotted stainless steel trays
- 2 brackets with thumbscrews
- 2 shaft adapters (for use with 3/8" or smaller rods),
see pictures to right.
 |
Align Holes Screw in just enough to capture adapter.
Now go to Step 1.
|
 |
CAUTION: Unit will be HOT in operation
- for protection use oven mitts when handling this product.
For easy clean up, put trays and/or brackets in dishwasher
when cool.
 |
If you have a question about the Rib-O-Lator
contact me at
info@ribolator.com
or call me at 206-999-0962 ask for Bob.
|
 |
|
